Login to Like
this post
If the pins are worn or not aligned, yes, they can cut holes like that. I don't think that this is a fake.
Login to Like
this post
I don't see anything wrong with it either, It's pretty typical.
Login to Like
this post
Several "authors" write that rotary press coils are never fake.
I agree that the perfs look genuine rather than the perfect, round, clean, fake perfs.
Larry
Login to Like
this post
Thank you everyone.
Login to Like
this post
This is listed as a 487 pair. It is not a very expensive pair, so not sure why someone would fake it, and since I don't think there is an imperf that matches this, how would they? That being said, these perforations look terrible. Besides not being punched well, the line goes up and down like a roller coaster. Can real perfs look this bad?
Login to Like
this post
re: Fake 487?
If the pins are worn or not aligned, yes, they can cut holes like that. I don't think that this is a fake.
Login to Like
this post
re: Fake 487?
I don't see anything wrong with it either, It's pretty typical.
Login to Like
this post
09:18:13am
re: Fake 487?
Several "authors" write that rotary press coils are never fake.
I agree that the perfs look genuine rather than the perfect, round, clean, fake perfs.
Larry
Login to Like
this post